Installation Guide

Modern Forms
www.modern forms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JAN 2019
2
INSTALLATION INSTRUCTIONS
219-LED Task Lamp
BL-21924
Fig.1
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear area.Be careful not to lose any small parts necessary for
installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (B) and back plate from the fixture.
4. Secure the mounting back plate to the junction box using the screw provided with the junction box.
NOTE: The side of the mounting plate marked "GND" must face out.
CONNECTING THE WIRES (Fig. 2)
5. Connect the driver’s input wires to junction box wires as shown (Fig. 2). Make sure that all wire connectors (A) are secure. If
your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s
ground wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the
junction box.
6. This lamp features a dimmer switch. Press and release to turn on / off. When fixture is on, press and hold the switch to
cycle from dim to bright and release when desired brightness is reached.
COMPLETING THE INSTALLATION
7. Secure the fixture to the mounting back plate using the mounting screw (B) .
Fig.2Wiring