Installation Guide

Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
FIG.
3 Wiring
4. Connect the driver's input wire to junction box wires as shown (Fig. 3). Make sure that all wire connectors (A) are secure. If your
outlet box has a green or bare cooper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground
wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the switch box.
5. Secure the mounting ring to the switch box using the junction box screw. Make sure the two holes (spacing 2-3/4") are horizontal as
shown (Fig. 2).
6. Secure the mounting plate (C) and conversion plate (D) to the mounting ring with assembly screw.
7. Place the fixture over the mounting plate, and secure it with mounting screw (B).
8. This lamp features a dimmer switch. Press and release to turn on / off. When fixture is on, press and hold the switch to cycle from
dim to bright and release when desired brightness is reached.
3
INSTALLATION INSTRUCTIONS
209- Task Lamp
BL-20922
modernforms.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous impro
vement program. Jan 2019
ANUARY, 2017
modernforms.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Conversion Plate Dimensions
Back Plate Dimensions Mounting Ring Dimensions
NOTE: The side of the mounting plate marked "GND" must face out.