Installation Guide

2
INSTALLATION INSTRUCTIONS
209- Task Lamp
BL-20922
Fig. 1 MOUNT ON SWITCH BOX
Fig. 2 MOUNT ON JUNCTION BOX
6. Place the xture over the mounting plate, and secure it with mounting screw (B).
7. This lamp features a dimmer switch. Press and release it to turn on / o. When xture is on, press and hold the switch to cycle from
OR
3. Remove the mounting screw (B) from the fixture.
4. Connect the driver's input wire to junction box wires as
shown (Fig. 3). Make sure that all wire connectors (A) are
secure. If your outlet box has a green or bare cooper ground
wire, connect the fixture’s ground wire to it. Otherwise,
connect the fixture’s ground wire directly to the back plate
using the green screw provided. After wires are connected,
tuck them carefully inside the switch box.
5. Secure the mounting plate to the switch box using the
screws provided with the switch box.
1. Shut off the power at the circuit breaker and remove
existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Be careful not to lose any small
parts necessary for installation.
PREPARATION
dim to bright and release when desired brightness is reached.
MOUNT ON 2”X4” SWITCH BOX (Fig. 1)
3. Remove the mounting screw (B) from the xture.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous impro
vement program. Jan 2019
ANUARY, 2017
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Switch Box
Mounting Plate
Fixture
Mounting Screw
Switch Box Screw
Wire Connector
Ground Wire
A
B
Switch
Driver
Ju
n
ct
i
o
n
Bo
x
Scre
w
M
ount
i
ng
R
i
ng
C
o
n
v
e
r
s
io
n P
la
t
e
Mounting Plate
Mounting Screw
B
G
round W
i
re
Ju
n
ct
i
o
n
B
o
x
Fixture
C
D
Switch
Driver
INSTALLATION
MOUNT ON 2”X4” SWITCH BOX (Fig. 1)
NOTE: The side of the mounting plate marked "GND" must face out.