Installation & Assembly

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (D1) and gaskets (C1) from the mounting back plate.
4. Secure the mounting back plate to the junction box using junction box screws (B1). The side of the mounting back plate marked
"GND" must face out.
CONNECTING THE WIRES (Fig. 2)
5. Connect the xture's wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture's ground wire to it. Otherwise, connect the xture's ground wire directly to the
back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
6. Secure the xture to the mounting back plate using the mounting screws (D1) and gaskets (C1).
7. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of the xture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape (Fig 3).
8. Adjust the xture shade to be parallel with the wall to meet the ADA compliance.
Ø 4 3/8"
Mounting Screw
Gasket
Junction Box Screw
Wire Connector
Junction Box
Canopy
Fixture
Back Plate Dimensions
D1
C1
B1
A1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
FIG. 1
INSTALLATION INSTRUCTION
556 - LED Outdoor
WS-W55607
Junction Box
Caulking
Fig. 3 Sealing
1 3/4"
1 3/8"
4 7/8"