User's Manual

AudioMVP™ Portable Stereo Media Player

Using CDs

Loading CDs:

1. Connect power (Follow Setup Power page 10.)

2. Press the CD Door Open Tab to open the CD Door.

3. Place a CD into the CD compartment. Close the CD Door.

Note: This unit can play CD Disc formats only.

4. Switch Source selector to CD position, in a few seconds total number

of tracks will appear on the display.

Playing CDs:

1. Follow the instructions for Loading a Disc.

2. Press the Play/Pause button to begin playing the loaded disc.

The Play/Pause indicator will light up.

3. Rotate the Master Volume dial to select the sound level.

4. To temporarily stop playing, press the Play/Pause button once.

To resume play, press the Play/Pause button again.

5. Press Skip/Search buttons to skip between tracks.

6. Hold the Skip/Search buttons to fast search through the track.

7. Press the Stop button to stop playing.

Track Programming (Up to 20 Tracks):

1. Load a CD.

2. Press the Prog button, the Prog indicator will turn on and a flashing

programmable number will show on display.

3. Press the CD Skip buttons to select the track.

4. Press the Prog button to confirm.

5. Repeat steps 3 and 4 to program to play in a specific order.

Repeat Source:

1. Follow the instructions for Loading CDs and Playing CDs.

2. Press the Repeat button, the Repeat indicator will turn on and flash.

The unit will play the current track repeatedly.

3. Press the Repeat button until the Repeat indicator is a solid light,

unit will play the entire disc repeatedly.

4. To cancel the repeat function, press repeatedly the Repeat button

until the Repeat indicator light turns off or press the Stop button

twice to stop.