Manualshelf

User's Manual

ManualsBrandsModern Electronics Factory ManualsElectronicsBluetooth CD Radio Microsystem
12345678910
LISTENING TO A CD
1.
Press SOURCE button until the display reads “CD”.
2. Press the EJECT/ENTER button to open the CD door, put a CD onto the CD
tray with the printed label facing up (towards you). To close the CD door, press
EJECT/ENTER button again.
Note: Remember to remove the CD when you are finished listening.
To Play a CD When Stopped: Press the /PAIR button. The disc will play
from track 1 and play indicator appears on the display.
To Pause a CD While Playing: Press the /PAIR button. The disc will pause and
play indicator blink on the display. Press the /PAIR button again to resume
playback.
To Stop a CD While Playing: Press the STOP button.
To Change Tracks: Press / TUN- button or / TUN+ button.
To Search During Playblack: Press and hold the / TUN- button or / TUN+
button until the desired section is located. While searching, sound will be played at
a distorted speed. Playback returns to normal when the button is released.
REPEATING PLAYBACK OF A TRACK OR A CD Press the REPEAT button
on the main unit or remote control to circle the play mode:
•
Repeat 1---Press the REPEAT button on the main unit or remote control
once and the current track will be played continuously
• Repeat All---Press the REPEAT button again and ALL tracks on the current disc
will be played continuously.
•
Normal playback --- Press REPEAT button again to resume normal playback.
Note: Pressing the STOP button will stop playback and the play mode will
be cleared.
PROGRAM PLAY
Program play must be set when the CD is stopped. You can program up to 20
tracks in any order.
1.
Press STOP button and then press MEM / PROG button on the main unit or
remote control.
2.
Press / TUN- button or / TUN+ button to select a track. The display
shows the selected track.
3.
Press the MEM / PROG button on the main unit or remote control to add
the track into the program list.
4. Repeat steps 2 and 3 until you complete the programming. You can program up
to 20 tracks.
To Start the Program Play: Press /PAIR button.
To Pause or Stop a Program Play: Press /PAIR or STOP button.
To Replay a Program: Press /PAIR button.
To Review the Content of a Program: Press STOP button then keep pressing
the MEM / PROG button to review the programmed tracks.
To Clear the Program: Press STOP button twice or open and close the CD
door.
7