User's Manual
Table Of Contents
- Bluetooth Portable CD Radio
- MPC5050
- MET36E
- MPC 5050
- MPC-5050
- Operation Guide
- Warnings and Precautions
- Location of the Controls
- Location of the Controls
- Power On the Unit
- Adjusting the Volume
- Adjusting the Rod Antenna
- Using Headphones
- Battery Operation
- AC Operation
- Use adapter 6V , 1.200mA (include).
- Connect the small end of adapter cable into the DC jack at the rear of the unit. Insert the adapter plug into a conveniently-located AC outlet. Please ensure that your mains supply is compatible before use.
- Getting Started / Main Operation
- DC Batteries / AC Power Operation
- Using the Radio
- Manual Tuning of Radio
- Storage the Radio Presets
- You can preset up to 20 stations for easy access as follows:
- Recall a Preset Station
- You can recall stored stations for easy access as follows:
- Listening the Radio
- Insert a CDs disc.
- Playing a CDs Disc
This unit can connected to mobile phones using a procedure by following a
few simple steps, a mobile phone can be paired with the unit in a matter of
seconds.
Setup Your Unit on Bluetooth ( BT) Mode
1. After power connect, press the POWER button to turn on your unit.
2. If necessary, press the SOURCE button to select (BT) mode ,
3. At the time, the “bt” digits flash on LCD display.
4. Finish this simply setting and go to next step below.
Set your Mobile Phone to ‘Discover’ Your Unit
1. First make sure that Bluetooth is activated on your mobile phone.
2. Then set your mobile phone to discover your unit.
3. This usually involves going to a ‘setup,’ ‘connect’ or ‘Bluetooth’ menu on
your mobile phone and selecting the option to ‘discover’ or ‘add’ a
Bluetooth device.
4. Your mobile phone will find the unit under name “MCP-5050”.
5. Your phone then asks if you want to pair with the unit.
6. Accept by pressing ‘yes’ or ‘ok’ on the phone.
7. Your phone will confirm when pairing is complete.
8. When successful pairing, the “bt” digits of LCD display will be light.
Warning:
In case of unsuccessful pairing, the “bt” digits would flash slowly. You must
follow the previous step to setting again or hold the PLAY / PAUSE / PAIR
button to manual connect again.
AFTER FIRST PAIRING
If the unit has already been paired with a Bluetooth enabled device before, it
will automatically start searching for the last paired device. Once it is found,
the “bt” digits will light. You can now start playing music from your Bluetooth
enabled device wirelessly to the unit.
Listening Bluetooth Device
8