User's Manual
Table Of Contents
- Bluetooth Portable CD Radio
- MPC5050
- MET36E
- MPC 5050
- MPC-5050
- Operation Guide
- Warnings and Precautions
- Location of the Controls
- Location of the Controls
- Power On the Unit
- Adjusting the Volume
- Adjusting the Rod Antenna
- Using Headphones
- Battery Operation
- AC Operation
- Use adapter 6V , 1.200mA (include).
- Connect the small end of adapter cable into the DC jack at the rear of the unit. Insert the adapter plug into a conveniently-located AC outlet. Please ensure that your mains supply is compatible before use.
- Getting Started / Main Operation
- DC Batteries / AC Power Operation
- Using the Radio
- Manual Tuning of Radio
- Storage the Radio Presets
- You can preset up to 20 stations for easy access as follows:
- Recall a Preset Station
- You can recall stored stations for easy access as follows:
- Listening the Radio
- Insert a CDs disc.
- Playing a CDs Disc
Power On the Unit
Press the POWER button to turn on or off unit.
Adjusting the Volume
Press the VOLUME buttons to increase or decrease the volume sound level.
Adjusting the Rod Antenna
The aerial should be extended to ensure good reception in FM radio modes. It
may be necessary to alter the position of the UNIT and/or aerial to achieve the
best signal.
Using Headphones
You will require headphones fitted with a 3.5mm diameter stereo plug and an
impedance of 8-32 ohms. The Headphone socket is located on the side of this
unit. This unit support 6 headphones correct together.
X-BASS (Bass Boost)
Press the XBASS button to turn on or off x-bass function.
Battery Operation
Before installing batteries (not
included), ensure that the UNIT is
disconnected from the mains
supply.
Remove the battery compartment
cover on the back of the unit by
carefully pushing the two lugs
down. The battery cover can then
be lifted away.
Fit 8 x 1 .5V C-size batteries (not included), referring to the polarity markings
inside the battery compartment. Never mix old and new batteries. Finally,
replace the cover.
For battery operation, switch off the mains supply and remove the cable from
the power socket Battery operation will be selected automatically.
AC Operation
Use adapter 6V , 1.200mA (include).
Connect the small end of adapter
cable into the DC jack at the rear of
the unit. Insert the adapter plug into
a conveniently-located AC outlet.
Please ensure that your mains
supply is compatible before use.
Getting Started / Main Operation
DC Batteries / AC Power Operation
5










