User's Manual
Table Of Contents
- Bluetooth Portable CD Radio
- MPC5050
- MET36E
- MPC 5050
- MPC-5050
- Operation Guide
- Warnings and Precautions
- Location of the Controls
- Location of the Controls
- Power On the Unit
- Adjusting the Volume
- Adjusting the Rod Antenna
- Using Headphones
- Battery Operation
- AC Operation
- Use adapter 6V , 1.200mA (include).
- Connect the small end of adapter cable into the DC jack at the rear of the unit. Insert the adapter plug into a conveniently-located AC outlet. Please ensure that your mains supply is compatible before use.
- Getting Started / Main Operation
- DC Batteries / AC Power Operation
- Using the Radio
- Manual Tuning of Radio
- Storage the Radio Presets
- You can preset up to 20 stations for easy access as follows:
- Recall a Preset Station
- You can recall stored stations for easy access as follows:
- Listening the Radio
- Insert a CDs disc.
- Playing a CDs Disc
Inserting or remove a Cassette Tape
1. To insert your cassette tape: Press the button to open the
cassette door. Insert your cassette tape into the compartment with
exposed section of the tape facing downwards. The side that your wish to
listen to or record onto should be facing towards you. Push the cassette
door until it locks in place.
2. To remove your cassette tape: press the button to open the
door then lift the cassette out.
Playing the Cassette Music
1. After power connect, press the POWER button to turn on your unit.
2. If necessary, press the SOURCE button to select TAPE mode.
3. When select correct , the “tAP” show on LCD display
4. Insert the cassette tape with the side that you want to listen and press the
button. Display backlight will be light on.
5. When the end of the recorded, the mechanism will stop automatically. If
you wish to play the other side of the tape, remove the cassette, turn it
round so that the other side is facing you, insert and Press the
button.
6. Press the button to fast forward / rewind though the tape.
7. Press the button when you have finished. Press the button
more to open the cassette door.
8. To avoid damage to the cassette mechanism and your tape, always press
the button between each operation.
Recording Other Source Music to Cassette Tape
1. Insert a cassette into cassette compartment.
2. Select correct source you want to recoding ( CD / FM / BT/ AUX / TAPE)
and start playing the selected source.
3. If select source to TAPE mode, you can speak the voice to recording.
You must
face to cassette door to start speaking.
4. Press the button to start recording.
5. To stop the recording : Press the button once.
6. To play back the recording: Press the button to rewind and
press the button to start playing.
Listening Cassette Music
10