Technical data

check float config

ModelSim EE/PLUS Reference Manual Simulator Command Reference

287

check float config

The

check float config

command allows you to write checking messages to a file

(default displays the message on your screen). You may also configure the float

time limit.

Syntax

check float config

[-file <filename>] [-time <limit>]

Arguments

-file <filename>

Specifies a file to write float messages to. Optional. If this option is selected, the messages

are not displayed to the screen.

-time <limit>

Specifies a time limit that a node may be floating. Optional. An error is detected if a node

is floating for as long or longer than the limit. The default limit is 0.