Technical data

check contention add
ModelSim EE/PLUS Reference Manual Simulator Command Reference
-
283
check contention add
The
check contention add
command enables contention checking for the
specified nodes. The allowed nodes are Verilog nets and VHDL signals of
std_logic and std_logic_vector. Any other node types and nodes that don't have
multiple drivers are silently ignored by the command.
Syntax
check contention add
[-r] [-in] [-out] [-inout] [-internal] [-ports] <node_name> ...
Arguments
-r
Specifies that contention checking is enabled recursively into subregions. Optional; if
omitted, contention check enabling is limited to the current region.
-in
Enables checking on nodes of mode IN. Optional.
-out
Enables checking on nodes of mode OUT. Optional.
-inout
Enables checking on nodes of mode INOUT. Optional.
-internal
Enables checking on internal items. Optional.
-ports
Enables checking on nodes of modes IN, OUT, or INOUT. Optional.
<node_name>
Enables checking for the named node(s). Required.
See also
"Bus contention checking" (p536)