Technical data

Setting default simulation options
ModelSim EE/PLUS Reference Manual ModelSim EE Graphic Interface
-
207
Setting default simulation options
Use the
Options > Simulation...
menu selection to bring up the
Simulation
Options
dialog box shown below. Options you may set for the current simulation
include: default radix, default force type, default run length, iteration limit,
warning suppression, and break on assertion specifications.
OK
accepts the
changes made and closes the dialog box.
Apply
makes the changes with the dialog
box open so you can test your settings.
Cancel
closes the dialog box and makes
no changes. The options found on each page are detailed below.
Note:
Changes made in the
Simulation Options
dialog box are the default for the current simulation only.
Options can be saved as the default for future simulations by editing the simulator control variables in the
modelsim.ini
file; the variables to edit are noted in the text below. You can use the
notepad
(p335) to edit the
variables in
modelsim.ini
if you wish. See also, "System Initialization/Project File" (p413) for more
information.
Default settin
g
s pa
g
e