Technical data

ModelSim EE/SE Command Reference ModelSim Commands CR-9
CRModelSim Commands
Chapter contents
Command reference table . . . . . . . . . . . . . . . . . 10
ModelSim Commands . . . . . . . . . . . . . . . . . . 19
The simulator commands used to control the ModelSim simulator are described in
this chapter. These commands are only valid after loading a design with the vsim
command
(CR-208) or via the ModelSim graphical interface. The commands here
are entered either in macro files or on the command line of the Main window.
Some commands are automatically entered on the command line when you use the
ModelSim graphical user interface.
Note that in addition to the simulation commands documented in this section, you
can add the Tcl commands described in the Tcl man pages (use the Main window
menu selection: Help > Tcl Man Pages).
Command syntax
See "Command Syntax and Conventions"
(CR-241) for complete command syntax
information.
Note: All commands entered within ModelSim must be entered in lower case.
Tcl and FLEXlm commands
Documentation for Tcl commands, and FlexLM commands are available in these
locations:
• Tcl man pages
available in HTML format - use this Main window menu selection:
Help > Tcl man pages
• FLEXlm commands
for tools available within ModelSim see "License administration tools"
(D-434)
in the User’s Manual; the complete FLEXlm user’s manuals is available at:
http://www.globetrotter.com/manual.htm