Technical data

add list
ModelSim EE/SE Command Reference ModelSim Commands CR-23
-in
For use with wild card searches. Specifies that the scope of the search is to include
ports of mode IN if they match the item_name specification. Optional.
-out
For use with wild card searches. Specifies that the scope of the search is to include
ports of mode OUT if they match the item_name specification. Optional.
-inout
For use with wild card searches. Specifies that the scope of the search is to include
ports of mode INOUT if they match the item_name specification. Optional.
-internal
For use with wild card searches. Specifies that the scope of the search is to include
internal items if they match the item_name specification. Optional.
-ports
For use with wild card searches. Specifies that the scope of the search is to include
all ports. Optional. Has the same effect as specifying -in, -out, and -inout together.
-<radix>
Specifies the radix for the items that follow in the command. Optional. Valid
entries (or unique abbreviations) are:
binary
octal
decimal (or signed)
unsigned
hexadecimal
ascii
If no radix is specified for an enumerated type, the default representation is used.
If you specify a radix for an array of a VHDL enumerated type, VSIM converts
each signal value to 1, 0, Z, or X.
-notrigger
Specifies that items are to be listed, but does not cause the List window to be
updated when the item changes. Optional.
-trigger
Specifies that items are to be listed and causes the List window to be updated when
the item changes. Optional. This switch is the default.
-width <n>
Specifies column width in characters. Optional.