Technical data

wlf2log
ModelSim EE/SE Command Reference ModelSim Commands CR-225
3 Do a connect_wdb (either through the pulldown menus, the "Connect WDB" pallette
icon under "Stimulus", or a function invocation). You specify the name of the WDB
that you originally loaded logfile into (in this case, "fred").
At this point you can issue the "run" command and the stimulus in the converted
logfile will be applied. Before exiting the simulation you should save the new
WDB ("fred") as a WDB or logfile so that it can be loaded again in the future. The
new WDB or logfile will contain the correct qsim_12state values eliminating the
need to re-use convert_wdb().