Technical data

property list
ModelSim EE/SE Command Reference ModelSim Commands CR-123
property list
The property list command changes one or more properties of the specified
signal, net or register in the List window
(10-174). The properties correspond to
those than can be specified using the List window Prop > Display Props menu
selection. At least one argument must be used.
Syntax
property list
[-window <wname>>] [-label <label>] [-radix <radix>]
[-trigger <setting>] [-width <number>] <pattern>
Arguments
-window <wname>
Used to specify a particular List window when multiple instances of the window
exist (i.e., list2). Optional. If no window is specified the default window is used;
the default window is determined by the most recent invocation of the view
command (CR-180).
-label <label>
Specifies the label to appear at the top of the List window column. Optional.
-radix <radix>
The listed value <radix> can be specified as: Symbolic, Bin, Oct, Dec or Hex.
Optional.
-trigger <setting>
Valid settings are 0 or 1. Setting trigger to 1 will enable the list window to be
triggered by changes on this signal. Optional.
-width <number>
Valid numbers are 1 through 256. Specifies the desired column width for the listed
<pattern>. Optional.
<pattern>
Specifies a name or wildcard pattern to match the full path names of the signals,
nets or registers for which you are defining the property change. Required.
To change the time or delta column widths, use these patterns:
TIME or DELTA