Technical data

profile clear
ModelSim EE/SE Command Reference ModelSim Commands CR-115
profile clear
The profile clear command is used to clear any data that has been gathered during
previous run commands. After this command is executed, all profiling data will
be reset.
This command has no effect on the current profiling session. The last profile on
or profile off command will still be in effect.
Syntax
profile clear
Arguments
None
See also
profile interval command
(CR-116), profile off command (CR-117), profile on
command
(CR-118), profile option command (CR-119), profile report command
(CR-120)
Note: Profiling must be active when this command is invoked. Use the profile on command (CR-118) to
begin profiling.