Technical data

Command reference table
ModelSim EE/SE Command Reference ModelSim Commands CR-11
batch_mode (CR-38) returns a 1 if VSIM is operating in batch mode, otherwise returns a 0
bd
(CR-39) deletes a breakpoint
bp
(CR-40) sets a breakpoint
cd
(CR-42) changes the VSIM local directory to the specified directory
change
(CR-43) modifies the value of a VHDL variable or Verilog register variable
change_menu_cmd
(CR-44) changes the command to be executed for a specified menu item
label, in the specified menu, in the specified window
check contention add
(CR-45) enables contention checking for the specified nodes
check contention config
(CR-46) write checking messages to a file
check contention off
(CR-47) disables contention checking for the specified nodes
check float add
(CR-48) enables float checking for the specified nodes
check float config
(CR-49) write checking messages to a file
check float off
(CR-50) disables float checking for the specified nodes
check stable off
(CR-52) disables stability checking
check stable on
(CR-51) enables stability checking on the entire design
checkpoint
(CR-53) saves the state of your simulation
configure
(CR-54) invokes the List or Wave widget configure command for the current
default List or Wave window
coverage clear
(CR-59) clears all coverage data obtained during previous run commands
coverage reload
(CR-60) seeds the coverage statistics with the output of a previous coverage
report command
coverage report
(CR-61) produces a textual output of the coverage statistics that have been
gathered up to this point
delete
(CR-62) removes HDL items from either the List or Wave window
describe
(CR-63) displays information about the specified HDL item
Command name Action