Technical data

Source window
52
-
ModelSim PE Graphic Interface Getting Started with ModelSim PE
Source window
The Source window allows you to view your VHDL or Verilog source code in read-only mode.
A marker at the left side of the window pane points to the next line to be executed.
If any breakpoints have been set, they are signified by a colored dot next to a line number. To
set a breakpoint, double-click at or near the right side of the line number. The breakpoints
toggle, so you can double-click again to delete an existing breakpoint. There is no limit to the
number of breakpoints you can set.