Specifications

Page 11
STEP 3: INSTALLING THE WING PANELS AND RETAINING CLIPS
q Gently slide the wing joiner tube into the left wing panel until the wing joiner
tube bottoms out.
q Carefully slide the other end of the wing joiner tube through the fuselage
and rmly push the wing panel up against the fuselage side.
q Slide one rubber O-Ring over each of the two wing mounting posts, followed
by one M6 at washer.
q While holding the wing panel rmly up against the fuselage side, install one
retaining clip through the hole in each of the two wing mounting posts.
PRO TIP Use a pair of needle nose pliers to make it easier to install and
remove the retaining clips.
q Slide the right wing panel onto the wing joiner tube and push it rmly up
against the side of the fuselage.
q Repeat the previous procedures to install the two rubber O-Rings, two M6
at washers and two retaining clips to secure the wing panel into place.
q 5 Minute and 30 Minute Epoxy
q Modeling Knife
q Straight Edge Ruler
q Pencil
q 220 Grit Sandpaper
q Masking Tape
q Airplane Stand
q (1) Horizontal Stabiliser with Elevator Halves
q (1) Vertical Stabiliser with Rudder
q (7) Pinned Hinges
q Machine Oil or Petroleum Jelly
q T-Pins
q Paper Towels
q Rubbing Alcohol
q Epoxy Mixing Sticks
q Epoxy Mixing Cups
q Heat-Sealing Iron
STABILISER INSTALLATION
YOU'LL NEED THE FOLLOWING PARTS FROM THE KIT:
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES: