Specifications
Page 10
q Remove the protective backing from the covering material. With the control
surface fully deected in the 'UP' position, place the length of covering material
over the hinge line (on the bottom), making sure that the crease is pushed
completely down into the hinge line.
IMPORTANT Only the bottom of the hinge gap needs to be sealed. It is
not necessary to seal both the bottom and the top.
q Repeat the previous procedures to seal the aileron hinge gap on the second wing panel. Both ailerons should be able to smoothly pivot
completely up and completely down without interference from the covering material.
q With the control surface fully deected in the 'UP' position, use a heat-sealing
iron to adhere the covering material to both the trailing edge of the wing panel
and to the leading edge bevel of the aileron.
q Trim the excess covering material ush with both surfaces, then pivot the
aileron up and down several times to check for free movement.
STEP 1: INSTALLING THE WING MOUNTING POSTS
q Test-t and glue two aluminium wing mounting posts into each wing panel,
using 30 minute epoxy. When aligned properly, the hole in each wing mounting
post should be 1/2" (13mm) out from the root ribs and each hole should be
aligned straight up and down to make it easier to install the retaining clips. Make
sure to remove any excess epoxy using a paper towel and rubbing alcohol.
IMPORTANT Make sure that you measure to the centre of the hole in each
wing mounting post and not to the end of each wing mounting post.
q 30 Minute Epoxy
q Needle Nose Pliers
q Modeling Knife
q Straight Edge Ruler
q (1) Fuselage with Cockpit Deck
q (1) Wing Joiner Tube
q (4) Knurled Aluminium Posts
q (4) Rubber O-Rings
q (4) M6 Flat Washers
q (4) Retaining Clips
q Paper Towels
q Rubbing Alcohol
q Epoxy Mixing Sticks
q Epoxy Mixing Cups
WING MOUNTING
YOU'LL NEED THE FOLLOWING PARTS FROM THE KIT:
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:
STEP 2: INSTALLING THE WING JOINER TUBE
q Remove the cockpit deck from the fuselage and set it aside for now.
q Cut away the covering material from over the wing mounting holes and the
aileron servo wire access hole in each side of the fuselage.