User Manual

Ifyouhavelightsandsoundfunctions,butnomovement,chancesarethelocoisnot
receivingtheCV#29packet,sotryonemorestepwhilethelocoisonthemainline;
Pressthe“Program”buttontwice.
Yourdisplaywillshow“Pro9MainTrack”
Press“Enter”.
Yourdisplaywillshow“LOCO,flashingaddressofyourloco,MainTrack”.
Iftheaddressflashingisthecorrectaddressforthisloco;
Pressthe“Enter”buttonsixtimes.
Yourdisplaywillshow“CV#MainTrack”with“___” underneath.
Input“29”,[forCV#29].
Press“Enter”.
Yourdisplaynowshows“CVMainTrack”,with“ ___”underneath.
Input“34”,[asavalue].
Press“Enter”
Pressthe“Recall”buttontoexittheProgramontheMainMode,andscrollfortheloco’s
address.
Tryrunninglocoagain.
Ifthisdoesnotwork,tryresettingthelocoaspertheinstructionstoit’sfactorydefault
settings.Thencontactthemanufacturerforfurtherguidance.
*NOTE:SomenewerlocomotiveswithQSIsoundsystemshaveanextraCVadded
tothem.CV#62let’syoudisable/enabletheverbalannouncements.Todisablethe
verbalannouncementssothedecoderdoesnotmisstheCV#29packetinputavalue
of“0”inCV#62.Onceyouhavethelocomotiveprogrammedyoucanthenenable
theverbalannouncementsbyinputtingavalueof“1”backintoCV#62.Please
consultyourlocomotivesinstructionbooktoseewhichversion ofQSIyouhave.
ProgrammingOlderDecodersWithTheAdvanceOrExpressOlderMRCdecoders
suchastheAD305,AD310,AD315,anddecodersfoundinolderAthearnandWalthers
TrainlineLocomotivescannotaccepttheaddressprogrammingpacketssentallatonce
bythesenewhighlyefficientDCCsystems.ThesamecouldbetrueofsomeolderDigi
Trax,N.C.E.,andLenzdecoders.Alsotheseolderdecodersmightnotaccept4digit
addressesoranyspeedstephigherthan14speedsteps,[eraticoperationofthelightsor
runningcharacteristicsmightbeencounteredifyouprogramthemtoeither28or128
speedsteps].Thesedecodersmightnotbeabletobe“ProgrammedOnTheMain”,or
“ReadBack”onaProgramTrack.
Toprogramthesetypesofdecoders:
PlacelocomotiveontheProgramtrack.
Pressthe“Program”buttononcetoentertheProgramMode.
Yourdisplaywillshow“Pro9ProgTrack”.
Pressthe“Enter”buttonsixtimes,[skippingovertheProgramAddressMode,andgoing
directlytotheCVProgramMode].
Yourdisplaywillshow“CV#ProgTrack”with “___” underneath.
Input“29”,[forCV#29].
Press“Enter”.
Yourdisplaynowshows“CVProgTrack’with “__ _ Data”underneath.