User Manual

To Synchronize the Speed Step to the Throttle

If the THROTTLE knob and the loco speed seem mismatched to the currently loco displayed,

press SPD STEP to synchronize the THROTTLE knob to the pre-programmed speed step in the

decoder.

1. Press SPD STEP to display current throttle encoder speed step.

2. Keep pressing SPD STEP until desired speed step is shown.

3. Press ENTER to lock in the speed step and resume to normal screen display.

Note Pressing the SPD STEP button does not change the decoder programming itself.

The decoder will remain at the programmed speed step. This synchronizes the amount of

THROTTLE knob movement from zero to full speed to match the decoder’s pre-programmed

speed step.

To Delete a Loco Address from Your Stack

1. Scroll through the stack by pressing RECALL to display the loco address you wish to delete

2. Press and hold DELETE for approximately 2-3 seconds. This feature lets you remove the

loco from your stack once you are done running it, or if you pass the loco to another

operator’s Cab.

3. Continue the above steps to delete as many locos as needed.

Note If you delete a loco address while it is running, it will not stop automatically. It will continue until

someone acquires it and either stops it or continues running it.