User`s manual
19
Wireless router
WPS: Checking this box and clicking “OK” will disable WPS function. WPS
is turned on by default.
WPS Status: When Router’s settings are factory default, it is set to open
security and un-congured state, some registers such as Vista WCN can
congure AP. Otherwise If it already shows “Congured”, it means that the
router has setup its security.
Self-PIN Number: Its is AP’s PIN.
Start PBC: Clicking this button will invoke the Push Button Conguration of
WPS. If one station wants to connect to the AP, you must click its PBC but-
ton within two minutes. You can see the WPS led ash this time.
Note: This router also has a hardware button, it is same button with reset.
When press this button for less than two seconds, the AP will run PBC func-
tion and the reset LED will ash for two minutes, during WPS session. The
station can connect to the AP by its software or hardware WPS button.
Please also note – If you press and hold this button 2 to 5 seconds, the rout-
er will reboot; more than 5 seconds, the router will restore factory default.
Client PIN Number: The length of PIN is limited to four or eight numeric
digits. If the AP and Station have the same PIN number typed in and clicked
“Start PIN” button within two minutes, they will establish connection and
setup their security key.
4.1.2 Access Control
The Wireless MAC Address Filtering feature allows you to control wireless
stations accessing the router, depending on their MAC addresses.