User`s manual
www.modecom.eu
16
Wireless USB Adapter
Except becoming a wireless client of other wireless access points, this USB
Wireless LAN utility can acts as a wireless service provider. You can switch
the operating mode to “Access Point” mode to simulate the function of a
real wireless access point by software, and all other computers and wireless
devices can connect to your computer wirelessly, even share the internet
connection you have.
To the Wireless LAN USB Adapter to bridge your wired and wireless net-
work, the following requirements must be met
1. The Wireless LAN USB Adapter must be installed on a computer con-
nected to the wired network.
2. Either congure network sharing (refer to the appendix for an example) or
bridge the two interfaces (wireless and wired) on the computer.
3. Set the wireless station’s IP address to be in the same subnet as the
computer in which the Wireless LAN USB Adapter is installed.
Select “Access Point” from Mode(M) tab to make the Wireless LAN USB
adapter act as a wireless AP.
After you select “Access Point” mode, the Wireless LAN USB adapter avail-
able options will change.
You will see the basic conguration menu of the AP function: