User`s manual

45
802.11n WLAN ADSL2+ Router
8. If the device PIN is correct and the WPS handshake is successfully done, AP’s
Wi-Fi Protected Setup page will be shown as below.
Other pages such as WirelessBasicSettingspage and WirelessSecuritySetup
page will also be updated appropriately as described in previous sections. In this
case, AP is in un-congured state before the station initiates the WPS handshake.
According to the WPS spec, AP will create a wireless prole with WPA2-mixed mode
and a random-generated key upon successfully doing the WPS handshake. How-
ever, AP will use the original wireless prole and give it to the station if AP is already
in congured state. That means all settings of AP will not change. Hence, all WPS
related pages keep the same.
Push Button method
Wireless Gateway supports a virtual button “Start PBC” on the Wi-FiProtected
Setuppage for Push Button method. If users push a virtual button “Start PBC”, AP
will initiate a WPS session and wait for any station to join. At this moment, AP will
detect whether there is more than one station that starts the PBC method. When
multiple PBC sessions occur, users should try PIN method.
After users push AP’s virtual button “Start PBC”, they must go to station side to
push its button within two minutes. If the WPS is successfully done, AP will give its
wireless prole to that station. The station could use this prole to associate with
AP.
1.From the left-hand Wireless->WPS menu. The following page is displayed:
2. Make sure AP is in un-congured state.
3. Click StartPBC.