User`s manual

www.modecom.eu
18
802.11n WLAN ADSL2+ Router
Testing your Setup
Once you have connected your hardware and congured your PCs, any computer
on your LAN should be able to use the device’s DSL connection to access the Inter-
net.
To test the connection, turn on the device, wait for 30 seconds and then verify that
the LEDs are illuminated as follows:
Table 1. LED Indicators
LED
Behavior
POWER
Solid green to indicate that the device is turned on. If this light is
not on, check the power cable attachment.
ETH
Flashing on/off while the device is booting. After about 10-15
seconds, solid green to indicate that the device can communicate
with your LAN.
Link
Flashing on/off while data is being transmitted. Solid green to
indicate that the device has successfully established a connec-
tion with your ISP.
INTERNET
Flashing on/off while data is being transferred. Solid green when
a valid IP address has been assigned to the device by the ISP.
If the LEDs illuminate as expected, test your Internet connection from a LAN com-
puter. To do this, open your web browser, and type the URL of any external website.
The LED labeled INTERNET should blink rapidly and then appear solid as the device
connects to the site.
If the LEDs do not illuminate as expected, you may need to congure your Internet
access settings using the information provided by your ISP. For details, see Internet
Access. If the LEDs still do not illuminate as expected or the web page is not dis-
played, seeTroubleshootingSuggestions or contact your ISP for assistance.
Default device settings
In addition to handling the DSL connection to your ISP, the DSL Modem can pro-
vide a variety of services to your network. The device is precongured with default
settings for use with a typical home or small ofce network.
The table below lists some of the most important default settings; these and other
features are described fully in the subsequent chapters. If you are familiar with net-
work conguration, review these settings to verify that they meet the needs of your
network. Follow the instructions to change them if necessary. If you are unfamiliar
with these settings, try using the device without modication, or contact your ISP for
assistance.