User`s manual

www.modecom.eu
110
802.11n WLAN ADSL2+ Router
Protocol The selections are TCP, UDP, ICMP and the blank
for none. This eld is required if the source port or
destination port has been entered.
Source Port The source port of the selected protocol. You cannot
congure this eld without entering the protocol rst.
Destination Port The destination port of the selected protocol. You
cannot congure this eld without entering the protocol
rst.
Physical Port The incoming ports. The selections include LAN ports,
and the blank for not applicable.
Fields on the second
setting block
Description
Outbound Priority The priority level for the trafc that matches this
classication rule. The possible selections are (in the
descending priority): p0, p1, p2, p3.
IP Precedence Select this eld to mark the IP precedence bits in the
packet that match this classication rule.
IP Type of Service Select this eld to mark the IP TOS bits in the packet
that match this classication rule.
802.1p Select this eld to mark the 3-bit user-priority eld
in the 802.1p header of the packet that match this
classication rule. Note that this 802.1p marking is
workable on a given PVC channel only if the VLAN tag
is enabled in this PVC channel.
Remote Access
The Remote Access function can secure remote host access to your DSL device
from LAN and WLAN interfaces for some services provided by the DSL device.
From the left-hand Advance menu, click on RemoteAccess. The following page
is displayed: