User`s guide
Table Of Contents
- NETWORK USER’S GUIDE
- Table of Contents
- 1 Introduction
- 2 Changing your machine’s network settings
- 3 Configuring your machine for a wireless network (For HL-2135W, HL-2270DW and HL-2275DW)
- Overview
- Step by step chart for wireless network configuration
- Confirm your network environment
- Confirm your wireless network setup method
- Configuration using the Brother installer application on the CD-ROM to configure your machine for a wireless network
- Configuration using the one-push wireless setting mode to configure your machine for a wireless network (Infrastructure mode only)
- Configuration using the PIN Method of Wi-Fi Protected Setup to configure your machine for a wireless network (Infrastructure mode only)
- Configuring your machine for a wireless network (for Infrastructure mode and Ad-hoc mode)
- 4 Wireless configuration using the Brother installer application (For HL-2135W, HL-2270DW and HL-2275DW)
- 5 Control panel setup
- 6 Web Based Management
- 7 Security features
- 8 Troubleshooting
- Appendix A
- Index
Control panel setup
28
5
Enabling or disabling the wireless network (For HL-2135W,
HL-2270DW and HL-2275DW) 5
If you want to switch the wireless network to enabled/disabled (disabled is the default), please follow these
steps:
a Make sure that the power cord is plugged in.
b Turn on the machine and wait until the machine is in the Ready state.
c Hold down Go for 10 seconds. Release Go when the machine prints a Network Configuration page that
indicates the current network settings.
Note
If you release Go in less than 10 seconds, the machine will print if you have any reprint data.
d Check the text to the right of IEEE 802.11b/g in the Node Type section. Active means that the wireless
setting is enabled and Inactive means that the wireless setting is disabled.
Note
You can switch the wireless network to enabled/disabled, using the BRAdmin applications or Web Based
Management (web browser). (For more information, see Other Management Utilities on page 6.)
<Node Type>
<Node Firmware Ver.>
<Ethernet Address>
<Node name>
<Active services>
Brother NC-XXXXw, IEEE 802.11b/g (Active)
Firmware Ver.0.20 (07.11.22)
XX-XX-XX-XX-XX-XX
BRWXXXXXXXXXXXX
BRNXXXXXXXXXXXX
BINARY_P1
TEXT_P1
POSTSCRIPT_P1
PCL_P1
BRNXXXXXXXXXXXX_AT