User`s guide
Table Of Contents
- NETWORK USER’S GUIDE
- Table of Contents
- 1 Introduction
- 2 Changing your machine’s network settings
- 3 Configuring your machine for a wireless network (For HL-2135W, HL-2270DW and HL-2275DW)
- Overview
- Step by step chart for wireless network configuration
- Confirm your network environment
- Confirm your wireless network setup method
- Configuration using the Brother installer application on the CD-ROM to configure your machine for a wireless network
- Configuration using the one-push wireless setting mode to configure your machine for a wireless network (Infrastructure mode only)
- Configuration using the PIN Method of Wi-Fi Protected Setup to configure your machine for a wireless network (Infrastructure mode only)
- Configuring your machine for a wireless network (for Infrastructure mode and Ad-hoc mode)
- 4 Wireless configuration using the Brother installer application (For HL-2135W, HL-2270DW and HL-2275DW)
- 5 Control panel setup
- 6 Web Based Management
- 7 Security features
- 8 Troubleshooting
- Appendix A
- Index
Control panel setup
26
5
Reset the network settings to the factory default 5
You can reset the print server back to its default factory settings (resetting all information such as the
password and IP address information).
Note
• This function resets all wired and wireless network settings to the factory default.
• You can also reset the print server back to its factory default settings using the BRAdmin applications or
Web Based Management (web browser). (For more information, see Other Management Utilities
on page 6.)
a Turn off the machine.
b Make sure that the front cover is closed and the power cord is plugged in.
c Hold down Go as you turn on the power switch. Keep Go pressed down until all the LEDs light up, and
then the Ready LED turns off.
d Release Go. Make sure that all the LEDs turn off.
e Press Go six times. Make sure that all the LEDs light up to indicate the print server has been reset to its
factory default settings. The machine will restart.