User`s guide
Table Of Contents
- NETWORK USER’S GUIDE
- Table of Contents
- 1 Introduction
- 2 Changing your machine’s network settings
- 3 Configuring your machine for a wireless network (For HL-2135W, HL-2270DW and HL-2275DW)
- Overview
- Step by step chart for wireless network configuration
- Confirm your network environment
- Confirm your wireless network setup method
- Configuration using the Brother installer application on the CD-ROM to configure your machine for a wireless network
- Configuration using the one-push wireless setting mode to configure your machine for a wireless network (Infrastructure mode only)
- Configuration using the PIN Method of Wi-Fi Protected Setup to configure your machine for a wireless network (Infrastructure mode only)
- Configuring your machine for a wireless network (for Infrastructure mode and Ad-hoc mode)
- 4 Wireless configuration using the Brother installer application (For HL-2135W, HL-2270DW and HL-2275DW)
- 5 Control panel setup
- 6 Web Based Management
- 7 Security features
- 8 Troubleshooting
- Appendix A
- Index
Wireless configuration using the Brother installer application (For HL-2135W, HL-2270DW and HL-2275DW)
24
4
(Windows Vista
®
)
1 Click the button and then Control Panel.
2 Click Network and Internet and then the Network and Sharing Center and Sharing Center icon.
3 Click Connect to a network.
4 You can see the SSID of the wireless printer in the list. Choose SETUP and click Connect.
5 Click Connect Anyway and then Close.
6 Click View status of Wireless Network Connection (SETUP).
7 Click Details.... and confirm the Network Connection Details screen. It may take a few minutes
to change from 0.0.0.0 to 169.254.x.x IP address to be shown on screen (where x.x. are numbers
between 1 and 254).
(Windows
®
XP SP2)
1 Click Start and then Control Panel.
2 Click the Network and Internet Connections icon.
3 Click the Network Connections icon.
4 Choose and right-click Wireless Network Connection. Click
View Available Wireless Networks.
5 You can see the SSID of the wireless printer in the list. Choose SETUP and click Connect.
6 Check the Wireless Network Connection status. It may take a few minutes to change from
0.0.0.0 to 169.254.x.x IP address to be shown on screen (where x.x. are numbers between 1 and
254).
(Macintosh)
1 Click the AirPort status icon in the menu bar.
2 Select SETUP from the pop-up menu.
3 Your wireless network is connected successfully.
d Follow the screen instructions to configure the wireless settings.
After you have completed the wireless setup, you can proceed to the printer driver installation.
Click Next in the installation dialog and follow the screen instructions.