User`s guide
Table Of Contents
- NETWORK USER’S GUIDE
- Table of Contents
- 1 Introduction
- 2 Changing your machine’s network settings
- 3 Configuring your machine for a wireless network (For HL-2135W, HL-2270DW and HL-2275DW)
- Overview
- Step by step chart for wireless network configuration
- Confirm your network environment
- Confirm your wireless network setup method
- Configuration using the Brother installer application on the CD-ROM to configure your machine for a wireless network
- Configuration using the one-push wireless setting mode to configure your machine for a wireless network (Infrastructure mode only)
- Configuration using the PIN Method of Wi-Fi Protected Setup to configure your machine for a wireless network (Infrastructure mode only)
- Configuring your machine for a wireless network (for Infrastructure mode and Ad-hoc mode)
- 4 Wireless configuration using the Brother installer application (For HL-2135W, HL-2270DW and HL-2275DW)
- 5 Control panel setup
- 6 Web Based Management
- 7 Security features
- 8 Troubleshooting
- Appendix A
- Index
Configuring your machine for a wireless network (For HL-2135W, HL-2270DW and HL-2275DW)
13
3
You can remotely configure the machine from a computer that is also on the network using a USB cable
(A)
1
.
1
You can configure the wireless settings of the machine using a USB cable temporarily connected to a wired or wireless computer.
(For HL-2270DW and HL-2275DW) If there is an Ethernet Hub or Router on the same network as the
WLAN access point (A), you can temporarily connect the Hub or Router to the machine using a network
cable (B). You can then remotely configure the machine from a computer on the network.
Configuration using the one-push wireless setting mode to configure your
machine for a wireless network (Infrastructure mode only) 3
If your WLAN access point/router (A) supports either Wi-Fi Protected Setup (PBC
1
) or AOSS™, you can
configure the machine without a computer.
1
Push Button Configuration
A
B
A
A