User manual

nication channel of the keyboard and mouse to the receiver is independent and

di erent, which means one receiver can receive signal only from one keyboard

and one mouse. Under below circumstances, you should do the „establishing

communication channel” operation:

• Your  rst time uses the combo;

• Re-installation or after charging the batteries;

• Other people use the same keyboard and mouse, and their communication

channel happens to be the same as yours, which causes disturbance;

• Someone establishes communication channel operation on you combo un-

consciously, but fails.

1. Press the CONNECT button at the bottom of the mouse once (<2seconds).

2. Within 5 seconds, press the CONNECT button on the receiver. Waiting for 10

seconds, if succeed in communication, the mouse

should be used normally, at the same time the com-

munication indicator LED will light on. If the mouse

fails to work normally after 10 seconds, please repeat

the previous step again. Remarks: For the  rst step, if

the pressing time is longer than 3 seconds, the mo-

use will be turned o manually; it will not change the

state of communication channel, so you do not need

to operate „The establishment of communication

channel between mouse and receiver” again.