User guide

Gateway Basics 10
Ethernet
WAN
Solid blue: The Ethernet WAN port is connected to a device and is ready.
Off: The gateway does not detect a link on this port.
Ethernet LAN
Solid blue: One or more local Ethernet ports 1 – 4 have detected wired links.
Off: The gateway does not detect links on these ports.
USB
Solid blue: The gateway has accepted the USB device and the USB device
is ready.
Off
: No USB device is connected.
Internet
Solid blue: The Internet connection is ready.
Solid amber: Network error.
Slow blinking amber: The gateway failed to cut over from an Internet WAN
connection to a mobile broadband connection.
Off
: No Internet connection.
Power
Solid green: The gateway is ready.
Slow blinking green: The gateway is powering up.
Solid red: System failure.
Slow blinking red: Thermal cutoff alarm.
Off
: No power is supplied to the gateway.
Wi-Fi On/Off
Solid blue: The wireless radios are on.
Off: The wireless radios are off.
WPS
Solid blue: WPS security is enabled.
Blinking blue: Someone is using WPS to join the gateway’s Wi-Fi network.
Off: WPS is not in use.
Micro-SIM
Your gateway comes with a preinstalled micro-SIM card that gives you access to the Sprint
network.
NOTE: Do not remove the SIM card. Hot swapping is not supported.
Launch Your Mobile Network Connection
After your gateway powers on and boots up, a connection to the best available network (3G or
LTE) is launched automatically.
Your gateway remains connected at all times, unless:
● You are out of signal range or the signal is blocked.
● You are in a roaming area and you have chosen not to allow roaming.