User guide

Set up a Virtual Private Network (VPN) 125
To add an IKE policy:
1. On a computer or wireless device that is connected to your gateway, launch a Web
browser.
2. In the address or URL field of your browser, type http://myrouter.
3. When prompted to log in, enter admin for the user name and type the password. (The
default password is password.)
4. Click Settings > Manage VPN > Site-to-Site Configuration.
5. In the IKE Policy section, click the Add button.
6. In the IKE Policy Name field, enter a unique name for the policy.
7. In the Local ID field, enter a user-fully qualified domain name ([e-mail]) or
a fully qualified domain name (www.mydomain.com).
Note: If the remote side of the tunnel is configured to expect an identifier, then both must
match in order for the negotiation to succeed. If NAT-T is being used, a single word
(instead of an address) can be used.
Note: If the Local ID field is blank, the gateway uses its own WAN IP address.
8. In the Remote ID field, enter an IP address, a user-fully qualified domain name
([e-mail]) or a fully qualified domain name (www.mydomain.com).
Note: If the remote side of the tunnel is configured to expect an identifier, then both must
match in order for the negotiation to succeed. If NAT-T is being used, a single word
(instead of an address) can be used. If the remote gateway is behind a NAT firewall then
Remote ID and Local ID cannot be blank.