Use and Care Manual

GCS09062H
4
Step 3:
• Connect the upper hanging bar(D)and
lower hanging bar(C)by using post plastic
part(T).
• Using M8x55 bolt(G),M8 washer(O)and M8
nut(Q),tighten all bolts using the hex
key(V)and wrench(W)add M8 screw
cover(Y) as shown below.
•
Attach the plastic muffler(S) to the hook of
upper hang bar(D).
Step 4:
• Attach the back frame (E) to the seat
frame (F) by lining up the bolt holes on the
back frame (E) with the corresponding bolt
holes on the seat frame (F).
• Using M6x45 combination bolt with washer
(K), M6 washer (M) and M6 nut (N), lightly
tighten all bolts using the hex key (V) and
the wrench (W).
• Tighten all bolts, then add M6 screw cover
(X) as shown below.
• Attach the plastic muffl
er (S) to the hook of
back frame (E).