Use and Care Manual

7. Pour ALL of the media (fire ice or lava rock) into the burner pan. The burner MUST be

completely covered to ensure the appliance functions properly and safely. Remove any lava

rocks or fire ice on top of the ignition well. See figure 8.

Figure 8

8. Slide the tank drawer out and place the LP tank in the drawer. Connect the regulator as

shown in Figure 9. Turn the black handle clockwise to tighten. Turn the handle counter

clockwise to remove. The hose must point down. Check that the valve is turned all the way

clockwise to the "OFF" position. Open the tank valve. Apply a solution of soapy water to the

tank-regulator connection and to the valve-hose connection to check for leaks. If soap

bubbles continue to form, the connection has a leak. If a leak is found, close the tank valve

and tighten all connections.

NOTE: NEVER USE A FLAME TO CHECK FOR LEAKS.

Figure 9

9. Tighten the threaded knobs found on the LP support frame (Figure 10) so that the LP tank

cannot move from side to side. Do not remove the plastic cap from the end of threaded

section.

Figure 10