Use and Care Manual

8
Figure 5
5. With the help of another person, carefully place the table top onto the firepit base. After
making any necessary adjustments to the alignment of the table top and the assembled
base, use four 1/4"x20 mm bolts and Ø20xØ6.5x2.0 mm washers as shown in Figure 6.
Guide the bolts through the holes in the base brackets, into the pre drilled holes in the table
top. Do not tighten completely.
Figure 6
6. Attach the U bracket to the LP support by using two 1/4"x15 mm bolts and Ø6.5x1.0 mm
washers as shown in Figure 7. Hand tighten only.
Figure 7