Use and Care Manual

FRS50006H
2
Egg Chair Assembly
Step 1:
• Place the seat frame (B) upside down on
a soft surface such as carpet.
• Attach the swivel base (C) to the seat
frame (B) by lining up screw holes on the
seat frame (B) with corresponding screw
holes on the swivel base (C).
•
Secure with M6*30 flat bolt with washer (H)
washer (F), spring washer ( E)and M6 nut
(D).loosely tighten using allen wrench (K)
and hex wrench(J).
• Do not completely tighten screws until all
screws are in place.
Step 2:
• Put the assembled swivel base (C) and
seat frame (B) upside down on a soft
surface such as carpet.
• Attach the back frame (A) to the seat
frame (B) by lining up screw holes on the
seat frame (B) with corresponding screw
holes on the back frame (A).
• Insert the connecting (I) into the upper
and lower tube.
• Do not completely tighten screws until all
screws are in place.
Step 3:
• Attach the back frame (A) to the seat
frame (B) and swivel base (C) by lining up
screw holes on the seat frame (B) with
corresponding screw holes on the back
frame (A).
• Secure with M6*50 bolt with washer
(G),washer (F) and M6 nut (D), tighten
using allen wrench (K) and hex wreanch
(J).
• Do not completely tighten screws until all
screws are in place.