Instructions / Assembly
Pumpkin Candle Hostess Gift  
By Cathie Filian & Steve Piacenza 
Supplies 
  Mod Podge ® Acrylic Shapes 
  Mod Podge Gloss 
  Mod Podge Dimensional Magic 
  Fall scrapbook paper 
  Pencil 
  Scissors 
  Glass Candle Holder 
  Ribbon 
  Jump-ring 
  Paintbrush 
  Paper towels 
  Foam plates 
Instructions 
Please read and follow all manufacturers’ instructions for all tools and materials used. Provide adult supervision if children participate in this 
project. 
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom 
from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained, 
Plaid Enterprises, Inc.disclaims any liability for untoward results. 
Beginner Skill Level | 1 Hour Crafting Time 
1.  Make the pumpkin pendant: Begin with a large rectangle Podgeable shape. Trim fall 
scrapbook paper to fit the top of the Podgeable shape. (You can use paper punches 
too) 
2.  Apply a thin coat of Mod Podge to the top of the Podgeable shape and to the back of 
the paper. Position the paper on the Podgeable. Smooth with your fingers. Apply a 
top-coat of Mod Podge. Allow to dry 2 hours. 
3.  Cover the Podgeable with Dimensional Magic. Begin around the outer edge and fill 
until the entire pendant is covered. Dry for 24 hours in an undisturbed and non-drafty 
place. 
4.  Trim the fall paper to fit on the front of the glass candle. Apply Mod Podge to the back 
of the paper and position on the candle. Smooth with your fingers to remove any air 
bubbles. Allow to dry. 
5.  Tie a bow around the neck of the candle and attach the Podgeable with a jump-ring 
or a piece of twine. 
Tip: While the Dimensional Magic is drying don’t move the pendant around or you might 
get air bubbles. If you do get an air bubble, use a sewing pin to pop it. 

