User manual

INSTALLATION

ONTO A WALL

MILLDROP can be placed on a working plane, mounted on the Millrack system (see the

relating User Manual) or installed on a wall (see Fig. A-B-C). In this last case, proceed as

follows:

1. Remove the screws (1) and the lid (A). Figure A

2. Remove the screws (2-3) and the side panel (B). Figure A

3. Position the panel (B) on the wall where MILLDROP has to be installed and mark the

wall by a pencil in the mounting slots (C). Figure B

NOTE

HE DEMINERALIZER MUST BE INSTALLED PERFECTLY HORIZONTAL, OTHERWISE

THE ANTI

-FLOODING SYSTEM COULD NOT PROPERLY FUNCTION. ON CHOOSING

THE INSTALLATION POINT

, CONSIDER THE ROOM NECESSARY FOR REAR PIPING,

FOR THE FRONT PANEL FREE VISION AND FOR THE ADEQUATE VENTILATION

(SEE

PARAGRAPH

GENERAL INSTALLATION PRECAUTIONS).

4. Bore the holes corresponding the marks just made. Figure C.

NOTE

EFORE DRILLING, BE SURE THAT NO PIPING OR ELECTRIC CABLES ARE INSIDE

THE WALL

5. Reassemble the side panel (B), fasten the screws (2 and 3).

6. Insert the screw anchors (4) in the holes, the screws (5) in the panel’s slots and screw

down. (Note: items 4 and 5 are not supplied) – see Figure C.

7. Reassemble the lid (A) and fasten the screws (1).

Figure A Figure B

Figure C