Specifications

APPENDIX E – ALARMS

which is automatically transformed to the message:

(Alarm Message)

RESET SYSTEM

80.5 °CXXXX

 0.00 bar



Perform a RESET (described below) and then turn-off the device and check the alarm.

NOTE

LARMS THAT INTERVENE OUTSIDE OF A PROGRAM DO NOT PRODUCE A PRINTED

REPORT

RESETTING THE

SYSTEM

The system is RESET in two alternative

ways, depending on the alarm that occurred (see the

Alarm Code List further below in this appendix):

1. Press the

PROGRAM SELECTION key for about 3 seconds.

A beep confirms the RESET;

WARNING

NEVER TURN THE DEVICE OFF BEFORE EXECUTING A RESET.

2. Turn-off the device

and then power-on using the main switch.

Upon power-up, the sterilizer will perform its normal initial test.

After RESET, and any technical intervention necessary to eliminate the fault, the device will go

to STAND-BY mode, ready to execute a new program.

>3s