Specifications
APPENDIX C – MAINTENANCE
75
Clean/replace the drain
filter
1
2
4
3
Replace bacteriological
filter
Replacing the printer
paper
Printer type 1
1
2
With use, various residues will probably tend to accumulate inside the filter, obstructing the
lower drain tube over time.
To clean (or replace) the filter, open the sterilizer door and remove the cap (1) with a 12mm
hex. wrench (supplied).
Loosen the fitting (2) that contains the filter(3).
Take the filter off the support and put it under running water to thoroughly clean. Use a sharp
tool, if necessary, to remove the larger foreign objects(use jets of compressed air, if possible,
to ease this operation).
If it is impossible
to reuse the filter, replace it with a new one.
NOTE
A
REPLACEMENT BACTERIOLOGICAL FILTER IS SUPPLIED WITH THE DEVICE. TO
REQUEST OTHERS
, PLEASE REFER TO APPENDIX Z, TECHNICAL SUPPORT..
Reinstall all the parts performing the procedure in reverse order, and being careful to screw
the fitting(2) in order to leave the drain holes (4) at the same level as the wall of the boiler.
NOTE
PROPERLY INSERT THE FILTER INTO ITS HOUSING; PARTIAL INSERTION MAY CAUSE DAMAGE TO
THE COMPONENT
.
When it is due to be changed, or when you notice visible clogging of the filter (indicated by a
color markedly tending towards gray) unscrew the bacteriological filter from its support and
replace it with a new one by screwing it all the way down on the connector on the front of the
machine.
NOTE
A
REPLACEMENT BACTERIOLOGICAL FILTER IS SUPPLIED WITH THE DEVICE. TO
REQUEST OTHERS
, PLEASE REFER TO APPENDIX Z, TECHNICAL SUPPORT.
To replace a used-up roll of paper in the printer:
1. open the door (1) of the service compartment to access the printer
2. Pressthetabsandthegreenbutton at the same time to open the door and access the
paper compartment.
3. remove the empty roll and place a new roll of thermal paper
so that the paper unrolls off
the top;
the roll must have the following dimensions:
- width 57 mm / diameter max 50 mm
4. unroll about 15 cm of paper and close the compartment door,
5. thread the paper in the slot of door of the service compartment and reclose.