Specifications
6. CONFIGURATION
28
As a function of the choices made, you will go to one of two alternative menus that allow selecting
the type of drying to associate to the selected program.
a) Programs with short drying (HOLLOW, SOLID, EMERGENCY):
→ STANDARD DRYING+
FAST DRYING↑
EXIT↓
‐
It is possible to select STANDARD mode (the default setting) or FAST (reduced drying,
recommended for light loads). Move using the + and - keys and confirm with the ↵ key.
NOTE
T
HE EMERGENCY PROGRAM PROVIDES ONLY FAST DRYING.
b) Programs with long drying (B CYCLE, WRAPPED, EXTRA):
→ STANDARD DRYING+
INTELL. DRYING↑
EXTRA DRYING↓
EXIT‐
It is possible to select STANDARD (default setting), INTELLIGENT (automatic drying that
adjusts its duration longer or shorter than standard drying on the basis of the volume
and/or quantity and type of load) or EXTRA (drying extended by a selectable value,
recommended for critical loads). Move using the + and - keys and confirm with the ↵ key.
NOTE
W
ITH LARGE LOADS OR SPECIAL MATERIALS, THE STANDARD OPTION MAY NOT
PROVIDE A PERFECT RESULT
. IN THIS CASE, EXTEND THE DRYING PHASE BY USING THE
EXTRA MODE.
W
ITH PARTICULARLY COMPLEX TYPES OF LOADS (SUCH AS WRAPPED INSTRUMENTS IN
A
"CONTAINER" FOR STERILIZATION) "INTELLIGENT" DRYING MAY NOT WORK
CORRECTLY
, WITH WORSE THAN EXPECTED RESULTS. IN THESE CASES, USE THE
STANDARD OR EXTRA OPTIONS, DEPENDING ON THE NEED.
When the EXTRA option is activated, the following screen appears:
EXTRA: XX min
+/‐to set
↵ to enter
⇑ to exit
which permits setting the duration of extra drying from between 1 and 15 minutes (time to
be added to the STANDARD DRYING time). Set the value using the + and - keys and
confirm the selection with the ↵ key.
NOTE
T
HE SELECTION CAN BE CHANGED AT ANY TIME BY FOLLOWING THE PROCEDURE
DESCRIBED ABOVE
.
W
HENEVER AN IDENTICAL STERILIZATION PROGRAM IS ALREADY PRESENT IN ANOTHER
POSITION
, THE SELECTION IS NOT ACCEPTED. THE FOLLOWING WARNING APPEARS ON
THE DISPLAY
, ALONG WITH A BEEP:
THIS PROGRAM
IS ALREADY PRESET