Specifications
4. INSTALLATION
15
CONNECTING AN
EXTERNAL
WATER FILLING
TANK
(OPTIONAL, automatic
filling function)
To avoid having to periodically fill the water tank (see Chapter 5, “First Start-Up”), it is
possible to connect the sterilizer to an external filling tank (supplied as an option), that the user
will periodically fill, or to a commercially-available, reverse-osmosis water purification system
with accumulation tank.
In that case, when the internal water tank reaches the MIN level, the autoclave activates a
pump that automatically fills the internal tank.
Follow the instructions below for the correct connection of the external tank:
– Install the tap provided on the filling tank; use Teflon tape or connector sealant for a perfect
seal.
Clip
Silicon pipe
Tap
Filling
tank
Clip
Teflon
– Use the filling tanks silicone tube (or other suitable tube, max length 2 m) and insert it on
the filling connector taking care to push it completely on.
– Lock the tube to connector with the plastic tie provided.
– Insert the other end of the tube on the tap of the filling tank.
– Make sure that the tube runs freely from the device to the filling tank, without being bent,
crushed or obstructed in any way.
– Loosen the upper plug to facilitate the flow of water (also remove any gasket or under-
plug);
– Open the tap on the filling tank.
NOTE
R
EFER TO THE CHAPTER, “CONFIGURING THE DEVICE
–
A
UTOMATIC FILLING OPTION ”.
CONNECTING
DEMINERALIZER
(OPTIONAL, automatic
filling function)
The sterilizer can be connected to a demineralizer (water purifier) to assure the tank is
automatically filled continuously with high quality demineralized water.
Consult the relative User’s manual for instructions on how to install the demineralizer.
NOTE
F
OR THIS OPTION SETTING, REFER TO CHAPTER “CONFIGURING THE DEVICE
–
AUTOMATIC FILLING OPTION”.
For additional information and advice about the correct connection of the sterilizer to the
various water purification systems, contact M.O.COM. customer support (see Appendix Z).
NOTE
B
ACKFLOW FROM THE MACHINE TO THE WATER CIRCUIT MUST BE PREVENTED BY USING
TOOLS THAT ARE IN CONFORMITY WITH LAW
IEC 61770.