User's Manual

developed by independent scientific organizations through periodic and thorough evaluation of scientific

studies. The standards include a substantial safety margin designed to assure the safety of all persons,

regardless of age and health. The exposure standard for wireless mobile phones employs a unit of

measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. *

Tests for SAR are conducted with the phone transmitting at its highest certified power level in all tested

frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level

of the phone while operating can be well below the maximum value. This is because the phone is designed

to operate at multiple power levels so as to use only the power required to r each the network. In general, the

closer you are to a wireless base station antenna, the lower the power output. Before a phone model is

available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit

established by the government adopted requirement for safe exposure. The tests are performed in positions

and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. The highest

SAR value for this model phone when tested for use at the ear is 0.41 W/Kg and when worn on the body,

as described in this user guide, is 0.65 W/Kg (Body-worn measurements differ among phone models,

depending upon available accessories and FCC requirements). The maximum scaled SAR in hotspot mode is

0.66W/Kg. While there may be differences between the SAR levels of various phones and at various

positions, they all meet the government requirement for safe exposure. The FCC has granted an Equipment

Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC

RF exposure guidelines. SAR information on this model phone is on file with the FCC and can be found

under the Display Grant section of http://www.fcc .gov/ oet/fccid a fter searching on

FCC ID: 2AKSAMOBULAA-NOTE Additional information on Specific Absorption Rates (SAR) can

be found on the Cellular Telecommunications Industry Association (CTIA) web-site at

http://www.wow-com.com. * In the United States and Canada, the SAR l imit for mobile phones used by the

public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a substantial

margin of s a fety to give additional protection for the public and to account for any variations in

measurements.