User manual
'%44).'34!24%$
",5%4//4(&/26/,+37!'%.-!.5!,
PAIRING YOUR BLUETOOTH PHONE
09
Phone Connected Display
When a phone is connected,
both the MFA+ and RNS-510/
RCD-510 will display the
current phone name, signal
strength, and network
name – provided your phone
supports the sending of
this information over
Bluetooth.
My Phone
Network Provider
PHONE
-&!$ISPLAY
&)'
2.32#$$ISPLAY
RADIO
MEDIA
PHONE
TIM
TP
SET UP
Switch off
microphone
My Phone
Network Provider
Memory 1
Memory 3
Memory 5
Memory 2
Memory 4
Memory 6
SOS
Call List
Now that the phone has been paired to
the system, it will connect and disconnect
automatically when ignition is turned on/off.
When the key is inserted and ignition is on,
mObridge will begin searching for all paired
devices, beginning with the most recent one
connected. It will do this until a connection
has been made. When ignition is switched
off and the key is removed, mObridge will
disconnect from any connected phone. If a
call is ongoing at this time it will transfer to
private mode on the handset.
NOTES
Some phones do not support automatic
connection – for these phones you will need to
manually connect to mObridge using the controls
on your phone.
Automatic connection & Disconnection
If your phone has a voice recognition function,
and your phone supports this functionality
over Bluetooth, it is possible to launch
your phone’s voice recognition via the
vehicle controls.
Note that not all phones support this
functionality. Consult the manufacturer
of your phone for more information.
Voice Recognition
To launch the voice recognition of your phone:
01 Ensure that a phone that supports
this functionality is connected to the
mObridge device.
02 On vehicles equipped with steering wheel
controls, a long press of the button
when not in a call will launch the voice
recognition.
03 On vehicles equipped with the stalk
control, a double-click of the OK button
when not in a call will launch the voice
recognition.