System information
31/118
Step 2: Setting Up The Keypad
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
2.2.1 Enter The Super PIN
You require the Super PIN during the initial startup of the keypad. The Super PIN is used
to protect your system. In an emergency, the Super PIN can be used in place of the admin
card for authentication on the keypad. The Super PIN therefore also allows you to erase
cards or set up a new access PIN.
The Super PIN should not have a series of zeros only and it must be dicult for unauthorized
persons to guess. Select a number that has at least eight and no more than 16 digits (using
the digits 0–9). The more digits the number has, the more secure it is.
Make a note of your personal Super PIN immediately in your T24 User Data Record Card
(see Section 3.2.2). Step 3 of the system startup process requires you to enter your Super
PIN on the videophone for authentication purposes (see Section 2.3.2).
Enter The Super PIN
1.
The keypad shows the flashing pattern of the successfully completed auto- configuration
process (ESC/ALARM flashes red, OK/MENU flashes blue).
2.
Enter your personal Super PIN and press the OK/MENU button (which then flashes
blue even faster).
3. Re-enter your Super PIN and press the (quickly flashing) OK/MENU button again.
4. A flashing ring pattern on the keypad confirms entry of the Super PIN.
5.
After approximately ten seconds, the number buttons on the keypad light up white
continuously, the keypad bell button, key button and OK/MENU button flash blue
and the ESC/ALARM button flashes red. Continue with Section 2.2.2.
Note
If you make an incorrect entry (for example, you enter two dierent Super PINs) or if you
wait longer than 60 seconds between two entries, a warning beep will sound and the
keypad will return to the original state it was in after auto-configuration (number buttons
will flash white). Repeat the procedure for entering the Super PIN, as described here.
0 9
Super PIN
OK
0 9
Super PIN
OK