Specifications
92/164
S15 Camera Manual: Installation
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
2.3 Installing the S15D FlexMount
Use the drilling templates supplied (at the end of the manual) to mark the position for
drilling the dowel holes for the camera and the sensor modules. Make sure that it is not
scaled down when printing or copying the drilling template.
Caution
Make sure the camera is mounted on an even surface. If this is not the case, there
is a risk that the housing plate will move and the housing will begin to leak.
The torque for the
housing cover screws
is 0.4Nm.
Only exchange sensor modules when powered o: Make sure that the camera‘s
power supply has been disconnected before attempting to exchange any sensor
modules.
2.3.1 Attaching the S15D Base Module
Depending on the system, the base module of a S15D can be installed quickly:
1. If necessary, mark the drill holes at the intended mounting position,
drill the holes for the base plate and hammer in the 6mm dowels
supplied.
1 2
Pressure compen-
sation
Base plate
R
L
LEDs
MicroSD card
Keys
Triple cable retainer
Bayonet catch
S15D housing cover
LED defaults:
1 Power (on), Error (ashes)
2 Recording (ashes)
The drilling templates
can be found at the
end of the manual
Always print or copy
drilling templates in
their original size