Specifications

75/156
Mounting the Camera Without Accessories
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
6. Mount the camera: Use the (included) screws to ax
the mounting ring and the camera at the designated
position.
7. Install the rubber seal: Place the rubber seal with the
groove around the edge of the black mounting ring of
the camera.
8. Attach the outer shell: Replace the outer shell and
screw all four Allen screws tight using the supplied
Allen wrench. Ensure that the rubber seal is properly
positioned.
9.
Clean the lens: If necessary, gently clean the front of the lens with a soft cotton cloth.
Do not apply excessive pressure to the surface of the glass when cleaning the lens.
10. Establish a connection to the camera, check the image: Establish a connection
to the camera as described in
Section 3.1 and the following sections. The live
image from the camera should be visible on the computer monitor. Check image
sections on the computer monitor as well.
Caution
The maximum torque for all screws is 1 to 1.2 Nm.
Only use the factory pre-installed network cable supplied with the MOBOTIX camera.
Always ensure that the cable retainer with bayonet catch is closed properly around
the network cable. All openings at the back of the camera housing except the pres
-
sure equalization element need to be sealed properly with the rubber plugs. This is
the only way to guarantee that the camera remains weatherproof.